Proper Mowing Enhances the Beauty of Your Lawn (05-28-13)

Proper Mowing Enhances the Beauty of Your Lawn

The one activity that we perform on our lawn more than anything else is mowing yet it is also the most often done with lack of attention to mowing height, regularity, leaf wetness, or sharpness of blade.  Any of these factors could cause undue turf stress and provide less than desired results.

Every turf species has its own optimum mowing height and any extremes from this may cause scalping, turf thinning, and even loss of the lawn.  Shade intolerant species like bermudagrass when maintained at a mowing height greater than two inches will begin to drop lower leaves from shading by the canopy above often creating a scalped appearance just after mowing when the top canopy is removed exposing the brown leafless stolons.  In contrast a St. Augustine lawn cut less than two inches in height may become wear stressed and lose turf density due to exposed stolons and reduced leaf area.  Recommended cutting heights for our warm season turf species are as follows: bermudagrass 0.5-1.5 inches; zoysia 1.0–1.5; carpetgrass 1.0-2.0 inches; centipede 1.5-2.0 inches and St. Augustine 2.5-3.0 inches.

Regardless of the turf species mowing regularity should follow the one-third rule.  This means never remove more than one-third of the total turf height at a single mowing.  Therefore, depending on the rate of growth and the desired maximum turf height this could require mowing several times a week for a hybrid bermudagrass lawn or perhaps as little as once every two weeks for a centipede lawn under low water and fertility management.  Assuming the growth rate is the same for a bermudagrass lawn kept at a one-inch height and a St. Augustine lawn maintained at 3 inches the bermudagrass lawn would require three mowing to one for the St. Augustine lawn.  When the on-third rule is followed leaf clippings will fall into the canopy of the turf and decompose rather quickly.  With irregular and improper mowing excess leaf clipping collect on the turf canopy shading the turf below, increases disease and insect incidences, and creates excess thatch.

Blade sharpness will determine the quality of cut and aesthetic appearance of the turf.  A dull mower blade will tear rather than cut leaving leaf tips split, ragged and brown.  It is best to avoid cutting the lawn when there is leaf wetness from rain or heavy dew especially when disease pressures are prevalent.

Published May 28, 2013

Dr. Wayne Wells is an Extension Professor and Turfgrass Specialist. His mailing address is Department of Plant and Soil Sciences, Mail Stop 9555, Mississippi State, MS 39762. [email protected]